Skip to Content

How-to

How to Change a Leather Watch Strap

Finer Hour November 5, 2026 3 min read

The short answer

A leather strap is held on by a small spring bar at each end. Measure the gap between the lugs, buy a strap that matches, then press the spring bar's end inward with a spring bar tool to release the old strap and fit the new one. It takes about five minutes with the right tool.

What you need

  • A new strap in the right width
  • A spring bar tool, which has a fine forked tip on one end and a pin on the other
  • A soft cloth or a towel to work on
  • Good light, and a tray or small dish so tiny parts do not roll away

Work over a table, not over a sink or a carpet. Spring bars are tiny and they can jump when released.

Step 1: Measure the lug width

The lugs are the two arms that stick out from the case at 12 and at 6 o'clock. The strap sits between them. Measure the gap between the inner edges of the lugs in millimeters. Most straps are sold in even sizes such as 16, 18, 20 and 22 mm, so a strap that matches the gap is the right one. For example, the Chisel green dial watch with a black leather strap in our wrist watches collection lists a 20 mm band width, so it takes a 20 mm strap.

The strap may taper toward the buckle. Its width is the number at the end that fits between the lugs.

Step 2: Release the old strap

  1. Lay the watch face down on the cloth.
  2. Find the spring bar, the thin metal rod between the strap and the lug. It has a tiny spring-loaded tip at each end.
  3. Fold the leather back a little so you can see the end of the bar where it meets the lug.
  4. Slide the fork of the tool between the strap and the lug. Press the shoulder of the bar toward the middle of the strap.
  5. The tip pulls out of its hole in the lug. Lift that end of the strap away, then slide the other end off.

Some straps have quick-release pins with a small tab. If yours has one, slide the tab and the strap comes off without a tool.

Step 3: Fit the new strap

  1. Check that the new strap has a spring bar fitted at its end. If it does not, move the bar from the old strap.
  2. Put one tip of the bar into its hole in one lug.
  3. Press the other end inward with the tool and guide it into the hole in the opposite lug.
  4. Release it. You should feel it click into place.
  5. Repeat on the other side.

Step 4: Check it is locked in

Hold the watch and tug the strap gently in each direction. It should not slip out or rotate loosely. Look at each end of the bar from the side to make sure the tip sits fully in the hole. A strap that is only half seated can come off on the wrist.

Tips

  • Put a layer of masking tape on the lugs if you worry about scratches.
  • Keep the old strap and bars in case you want to go back.
  • Break in a new leather strap by wearing it a few times. It is stiff at first and then softens.
  • If the lugs have no holes on the inside, or the bar does not move, stop and ask a jeweler.

More guides