The short answer
Turn the crown clockwise until you feel firm resistance, then stop, at about the same time each day. On a stem-set watch the crown has two positions: pushed in it winds, pulled out it sets the hands. On a lever-set watch you pull out a small lever under the bezel first, then turn the crown. A quartz pocket watch runs on a battery and needs no winding.

First, check which kind you have
A mechanical pocket watch runs on a spring that you wind by hand. A quartz pocket watch runs on a battery, so skip the winding steps and only set the time. If you're not sure, the product page or the paper that came with your watch will say.
How to wind it
- Hold the watch in one hand, and take the crown between your thumb and finger with the other.
- Turn the crown clockwise in short, slow turns.
- Stop as soon as you feel firm resistance. Don't push past it, because forcing the crown can damage the spring.
- Wind it at about the same time each day. Morning is a good habit, since the watch then has a full spring through the day.
How to set the time: stem set and lever set
Pocket watches set the time in one of two ways. Most modern ones are stem set; some, especially older or railroad-style watches, are lever set.
Stem set
The crown has two positions. Pushed in, turning it winds the watch. Pulled out until it clicks, turning it moves the hands.
- Gently pull the crown out until you feel it click into the setting position.
- Turn it to move the hands to the right time. Move them forward rather than backward.
- Push the crown back in to the winding position.
Lever set
Here the crown only winds. A small lever, usually hidden under the front bezel or crystal near the edge of the dial, switches it to setting the hands. Railroad watches used this design so the time could not be changed by accident.
- Open the front bezel or crystal, following your watch's instructions.
- Pull the small lever out with a fingernail.
- Turn the crown to set the hands, then push the lever back in and close the bezel.
If the crown won't pull out and you can't find a lever, check the paper that came with the watch before forcing anything.
Opening a hunter case
A hunter case has a metal cover over the dial. On most, pressing the crown or a small button pops the cover open. Close it with a gentle press until it clicks, and hold the button in as you close it if your watch has one, which saves wear on the catch.
Everyday care
- Keep it away from water and strong magnets. Most pocket watches aren't made for either.
- Carry it in a pocket with nothing else in it, or in a holder, to avoid scratches.
- Attach a chain so a slip doesn't turn into a drop. See our accessories.


